Configuring Link Aggregation in Manual Load on Huawei S5300

Balancing Mode

Create an Eth-Trunk on SwitchA and add member interfaces to the Eth-Trunk. The configuration

of SwitchB is similar to the configuration of LS-S5328C-PWR-SI, and the configuration details are not

mentioned here.

<HUAWEI> system-view

[HUAWEI] sysname SwitchA

[SwitchA] interface Eth-Trunk1

[SwitchA-Eth-Trunk1] trunkport gigabitethernet 0/0/1 to 0/0/3

[SwitchA-Eth-Trunk1] quit

Step 2 Create VLANs and add interfaces to the VLANs. The configuration of SwitchB is similar to the

configuration of SwitchA, and the configuration details are not mentioned here.

# Create VLAN 10 and VLAN 20, and add interfaces to VLAN 10 and VLAN 20.

[SwitchA] vlan batch 10 20

[SwitchA] interface gigabitethernet 0/0/4

[SwitchA-GigabitEthernet0/0/4] port link-type trunk

[SwitchA-GigabitEthernet0/0/4] port trunk allow-pass vlan 10

[SwitchA-GigabitEthernet0/0/4] quit

[SwitchA] interface gigabitethernet 0/0/5

[SwitchA-GigabitEthernet0/0/5] port link-type trunk

[SwitchA-GigabitEthernet0/0/5] port trunk allow-pass vlan 20

[SwitchA-GigabitEthernet0/0/5] quit

# Configure Eth-Trunk 1 to allow packets from VLAN 10 and VLAN 20 to pass through.

[SwitchA] interface Eth-Trunk1

[SwitchA-Eth-Trunk1] port link-type trunk

[SwitchA-Eth-Trunk1] port trunk allow-pass vlan 10 20

Step 3 Set the load balancing mode of Eth-Trunk 1. The configuration of SwitchB is similar to the

configuration of SwitchA, and the configuration details are not mentioned here.

[SwitchA-Eth-Trunk1] load-balance src-dst-mac

[SwitchA LS-S5352C-SI -Eth-Trunk1] quit

Step 4 Verify the configuration.

Run the display eth-trunk 1 command in any view to check whether the Eth-Trunk is created

and whether member interfaces are added.

[SwitchA] display eth-trunk 1

Eth-Trunk1's state information is:

WorkingMode: NORMAL Hash arithmetic: According to SA-XOR-DA

Least Active-linknumber: 1 Max Bandwidth-affected-linknumber: 8

Operate status: up Number Of Up Port In Trunk: 3

--------------------------------------------------------------------------------

PortName Status Weight

GigabitEthernet0/0/1 Up 1

GigabitEthernet0/0/2 Up 1

GigabitEthernet0/0/3 Up 1

The preceding command output shows that Eth-Trunk 1 has three member interfaces:

GigabitEthernet0/0/1, GigabitEthernet0/0/2, and GigabitEthernet0/0/3. The member interfaces

are both in Up state.